Single Crystal to Single Crystal (SC‐to‐SC) Transformation from a Nonporous to Porous Metal–Organic Framework and Its Application Potential in Gas Adsorption and Suzuki Coupling Reaction through Postmodification

A new amino‐functionalized strontium–carboxylate‐based metal–organic framework (MOF) has been synthesized that undergoes single crystal to single crystal (SC‐to‐SC) transformation upon desolvation. Both structures have been characterized by single‐crystal X‐ray analysis. The desolvated structure shows an interesting 3D porous structure with pendent ?NH₂ groups inside the pore wall, whereas the solvated compound possesses a nonporous structure with DMF molecules on the metal centers. The amino group was postmodified through Schiff base condensation by pyridine‐2‐carboxaldehyde and palladium was anchored on that site. The modified framework has been utilized for the Suzuki cross‐coupling reaction. The compound shows high activity towards the C?C cross‐coupling reaction with good yields and turnover frequencies. Gas adsorption studies showed that the desolvated compound had permanent porosity and was microporous in nature with a BET surface area of 2052 m² g^?1. The material also possesses good CO₂ (8 wt %) and H₂ (1.87 wt %) adsorption capabilities.     

Selective Propargylation of Carbonyl Compounds and Imines with Barium Reagents

A Barbier‐type regioselective propargylation of aldehydes and ketones with (3‐bromobut‐1‐ynyl)trimethylsilane has been achieved using reactive barium as a low‐valent metal in THF. Especially in the case of ketones, the corresponding homopropargylic alcohols form almost exclusively. In the reaction of α,β‐unsaturated carbonyl compounds, only 1,2‐adducts have been observed. This method is also applicable to propargylation of imines, and the corresponding homopropargylic amines are obtained regiospecifically in good yields with diastereomeric ratios of up to 87:13.     

掺氢与激励电路对钡蒸气激光输出特性的影响

对用Blumlein电路放电激励的钡蒸气激光在掺氢和不掺氢时的输出特性进行了实验研究.结果表明，用掺氢1.5%的氖气作缓冲气体能使激光功率增加近2倍.在此基础上，进一步比较了相互作用电路与Blumlein电路时钡蒸气激光的输出特性，发现相互作用电路能显著提高钡蒸气激光的输出功率和效率，获得了3W最大功率和0.4%效率的1.5μm波长激光输出.测量并分析了各工作参量与激光功率之间的关系，定性解释了掺氢与相互作用电路的作用机理 . 关键词： Blumlein电路 相互作用电路 掺氢 钡蒸气激光     

Bi12TiO20纳米粉体的制备及其光吸收特性研究

以钛酸四丁酯和硝酸铋为原料 ,利用化学溶液分解法制备了Bi12 TiO2 0 纳米多晶粉体 .采用XRD和TEM对其结构和形貌进行了表征 .结合热重 差热 (TG DTA)分析 ,探讨了Bi12 TiO2 0 晶相的形成机理 .通过UV Vis漫反射谱的测定 ,研究了Bi12 TiO2 0 纳米晶粉体的光吸收特性 .结果显示 ,从组成为化学计量比的前驱液中可以很容易制得纯Bi12 TiO2 0 纳米晶粉体 ,该Bi12 TiO2 0 纳米晶粉体呈现了在很宽的波长范围内 (5 6 0～ 385nm )对光的吸收的特性 .     

Precipitation and characterization of uniform submicrometer lead titanate particles. Part II: Reaction mechanism

The chemical mechanism of the precipitation of lead titanium peroxohydroxide particles in a solution of nitrilotriacetate (NTA) complexes of lead and titanium peroxo-hydroxide is envisioned as the interaction between cations of lead hydroxide and anions of polymeric titanium peroxo-hydroxide.     

非晶钛酸铋的晶化过程

利用差热分析、X射线衍射和透射电子显微镜等技术对溶胶-凝胶法合成的凝胶的晶化过程进行了分析，实验结果表明，Bi₄Ti₃O₁₂非晶凝胶晶化过程经历了四个过程：首先在433℃先形成了Bi₂O₃和TiO₂亚稳相，然后在488℃时TiO₂亚稳相与Bi₂O₃反应形成Bi，Ti复合氧化物亚稳相Bi₂T 关键词： 钛酸铋 铁电材料 溶胶凝胶 非晶 晶化过程     

Effect of post-metallization annealing on the ferroelectric properties of sol-gel derived PZT thin films

A series of monolithic Pt-PZT-Pt capacitors was prepared based on sol-gel derived PZT 53/47 films fired to 700 C. After deposition of top Pt electrodes, the capacitors were subjected to post-metallization annealing (PMA) temperatures of 100 C to 700 C. Dielectric and ferroelectric (FE) characterizations were performed. Increasing the PMA temperature produced lower values of spontaneous and remanent polarizations, dielectric constant and leakage currents. The observations are correlated with a proposed FE capacitor model.     

Effects of barium on the nonlinear electrical characteristics and dielectric properties of SnO2-based varistors

The effects of barium on electrical and dielectric properties of the SnO_2·Co_2O_3·Ta_2O_5 varistor system sintered at 1250℃ for 60min were investigated. It is found that barium significantly improves the nonlinear properties. The breakdown electrical field increases from 378.0 to 2834.5V/mm, relative dielectric constant (at 1kHz) falls from 1206 to 161 and the resistivity (at 1kHz) rises from 60.3 to 1146.5kΩ·cm with an increase of BaCO_3 concentration from 0mol% to 1.00mol%. The sample with 1.00mol% barium has the best nonlinear electrical property and the highest nonlinear coefficient (α=29.2). A modified defect barrier model is introduced to illustrate the grain-boundary barrier formation of barium-doped SnO_{2}-based varistors.     

Inorganic Sol-Gel Preparation of Medium Sized Microparticles of Li2TiO3 from TiCl4 as Tritium Breeding Material for Fusion Reactors

Microspheres of Li₂TiO₃ were fabricated by a classical, inorganic sol-gel process from commercially available TiCl₄. Elaborated process consists of the following main steps: (1) dissolving of TiCl₄ in concentrated aqueous HCl and addition of LiOH; (2) formation of sol emulsion in 2-ethylhexanol-1 containing the surfactant SPAN-80 (EH); (3) gelation of emulsion drops by extraction of water with partially dehydrated EH; (4) impregnation of gel to Li:Ti molar ratio MR = 2; (5) thermal treatment at 1200°C in order to receive chloride free product. This temperature can be significantly lowered (to 750°C) by dechlorination starting solution TiCl₄ by chemical treatment of the with nitric acid to form of nitrate-stabilized titania sols. Tritium release from sol-gel made Li₂TiO₃ microspheres were found very close to that observed for other traditional materials, however for the first sample process starts slightly earlier.     

Eu,Dy共掺杂SrAl2O4长余辉材料制备新工艺

活化Al-Sr合金粉末水解制备SrAl₂O₄长余辉材料的前驱体,并采用高温固相反应法制备出Eu,Dy共掺杂的SrAl₂O₄长余辉材料,对其微观结构和发光特性进行了研究。实验结果表明:前驱体中Al、Sr元素在微观状态下分布均匀,所制成的长余辉发光材料的发射主峰位于520nm附近,为典型的Eu²⁺离子4f5d-4f的特征发射,初始亮度达到18cd/m²,余辉时间长达46h。